Module Mounting structure

In order to support PV Modules, you will need a good structure to go along with it. This can be achieved with the help of a module mounting structure. A module mounting structure is used to align PV modules towards a particular orientation in order to receive the highest amount of sunlight. Before the construction of any module mounting structure, certain factors are taken into consideration.
Some of them are:

• Total load of the PV module assembly
• The maximum wind load of that particular location also keeping in mind the height of the installation
• Safety factors of the Seismic Zone
• Saline or corrosive environment considerations

It is important to note that all these physical considerations are governed by Indian Standards. These modules are usually aligned at tilt angles which are usually lower than the optimum angle for maximum solar energy penetration. With the help of lower tilt angles, the effect of wind velocity is reduced which results in a lighter system and also helps avoid any puncture of the terrace which could possibly result in problems such as water seepage.

In order to garner maximum potential of the MMS, techno-commercial considerations must be taken into account rather than just in terms of technical performance.